Test prop

In terms of ancillaries, the use of anti-estrogens is advised. For cutting puposes one will want to run Proviron alongside the testosterone for the length of the stack, which will rarely make the use of other anti-estrogens a necessity. If no Proviron or arimidex is used, you may want to keep some Nolvadex handy. Should problems arise starting on 20-40 mg of Nolvadex until a while after problems subside should be sufficient for all intents and purposes. Testosterone, being a heavily aromatizing compound, is also quite suppressive of natural testosterone (most so, safe for nandrolone) so a post-cycle therapy with Nolva/Clomid and HCG is necessary. Usually one will start HCG the last week or two weeks of a stack and run it about 4 weeks. HCG shots of 1500-3000 IU given every 5th or 6th day. That means during the end of a cycle, one shot of HCG is given per two shots of testosterone. A user should also opt to wait on using clomid or Nolvadex until the androgen is cleared. For longer esters that was to 2 weeks, obviously that time-frame should be reduced to 1 week or even half a week for propionate. One will then start on either 40-50 mg of Nolvadex or 150 mg of Clomid per day for a period of two weeks, and then follow it up with 20-25 mg of Nolvadex or 100 mg of Clomid per day for another two weeks. Post-cycle therapy will facilitate the return of natural testosterone and make it more likely for the user to retain most of the mass he gained while on the cycle.

A handy tool for this project is the drying rack for the eyes. I made mine from two 4″ pieces of wire coat hanger and a small flat piece of scrap wood. Just drill two appropriately sized holes in the wood, cut two straight pieces of wire coat hanger and insert them in the holes. You will need to make sure that the drill bit is the same diameter as the coat hanger to ensure a tight fit. For the record, I used a thin wire hanger and a 47 gauge (″) drill bit. This will allow you work around the eyes completely without getting your fingers in the paint, and to set them aside to dry on your work surface. 

Test prop

test prop

Media:

test proptest proptest proptest proptest prop